Compressor Condensate Oil Water Separator
Air & Gas Compressor Condensate Oil Water Separator (CCS)
CCS Air Compressor Condensate Oil Water Separator
This oil water separator is specifically designed to handle air compressor condensate. This separator has NO moving parts and is nearly maintenance free. It’s designed to give turbulent free plug flow for maximum oil water separation. A large turbulence free separation chamber provides sufficient residence time for coalescing gravity separation, and the effluent header design and placement insures maximum residence time for separation.
Rugged construction, proper selection and a proven design will assure you of a clean discharge, eliminating the concerns of environmental compliance.
Here’s how it works:
There’s a LOT of oil out there……Let’s keep it in the right places!
During the compression process, outside contaminants such as water vapor, dirt, junk and dust are mixed in with the hot oil. Once the air has cooled down at the end of the compression process, the contaminated condensate is generated.
If this moisture collects anywhere in the distribution system (mainly air receivers, filter bowls or moisture separators), the condensate will get into the compressed air system and cause damage to the pneumatic equipment/system and possibly ruin or cause quality problems with the final product.
Typically a good portion of this condensate winds up going to the lowest spot in the plant’s air delivery system…..such as the scale pits in steel mill operations.
Because of this unavoidable, inconvenient and VERY expensive by-product of using compressed air, an oil-water separator is necessary and beneficial to any compressed air operation.
Environmental concerns have produced tough new standards to follow and stiff penalties for those who don’t comply. Most states now consider air compressor condensate as a hazardous waste. In other areas it is at least considered to be a special oily waste, with discharge limits to POTWs or municipal treatment plants. Some plants have it hauled off.
Click here to properly size the Condensate Oil Water Separator for your application.
How it works:
The 3 Stages of separation:
#2. A second stage of gravity separation plus coalescing media (polypropylene balls or tubes) provides greater turbulence-free residence time for further separation.
#3. A large volume External activated carbon polishing filter (GAC) provides clean and sheen-free water for discharge. Almost all sewer districts accept water from a carbon filter.
As indicated above, coalescing, gravity separation and carbon absorption are the three separation methods used by the Compressor Condensate oil water separator (CCS).
Call us on this one. Our people are trained to properly size a unit for your application. While this is not rocket science, it helps to know what you’re doing. We specialize in getting oil out!
Frequently Asked Questions
HOLD IT HOLD IT HOLD IT….MY OIL DOES NOT SEPARATE …..HUH?
Wait…..I have some condensate with oils that don’t separate out. What now?
Also, keep in mind, lubricants which are miscible with water (polyglycols) or contain additives (ATF’s) such as detergents which cause the lubricant (oil) to form stable emulsions with water, and cannot be separated using any ordinary type gravity separation devices.
See the purpose built ConEVAP….designed to evaporate your condensate away with:
See the simple BUBBA PROOF ConEVAP compressor condensate evaporator with only one moving part.
With some compressor oils …gravity and coalescing separation is impractical even impossible. Some compressor oils are designed to go into solution and be impossible to separate. It that case, the condensate has to be hauled off or even evaporated away to atmosphere. Usually compressor oils will boil off at 600 + degrees F, which would allow you to evaporate the water off and leave the compressor oil behind.